Fabreeko

Tiny-M mod bed  5/16th thick Mic 6 (ATP5) aluminum  150*150 measurements to BOM specs +/- 0.015” tolerance 

Made out of Aluminum 2020 extrusuion Blind Joints  built to tiny-m specs for 150mm bed

used for input shaper in klipper The ADXL345 is 3-axis accelerometer with high resolution  measurement at up to +/-16 g. Digital output data is  a...

F625 2rs Bearings

60w 24v heater standard size fits most creality blocks and other Standard and Heavy Duty can achieve temperatures over 350C in a very short time. ...

This is a complete Slice Engineering copperhead block and heat Break finished with a “v6 style” heatsink for drop-in compatibility with Creality cr...

Spring Steel sheet measuring .5 mm thickness  Sabic Ultem (PEI) 1000 is used for the smooth side for its superior ability to handle heat cycles...

klipper expander is a Simple MCU board for use with Klipper 3D Printer firmware with: STM32F042F6P6 MCU with internal oscilator SWD (Serial Wire De...

These socks will keep your nozzle clean and free of burnt on blackened plastic. They don’t just keep the nozzle clean, but also keep heat inside t...

multi purpose 6mil thickness for improved durability and protection nitrile and powder free single use available in 3 sizes **Larger quantities a...

Fused power inlet for V0.1 **Does not come with fuse**Standard: IEC 60320 C14Rating: 15A 250V AC / 10A 250V ACInsulation Resistance: 100MΩ 500V DC ...

Rubber feet for V0.1 comes in a set of 4

In stock! **350 mm ships in 15-20days**for Trident and V2.4Set of 3 backers 

Endstop pcb for x and y available in both mechanical and hall effect versions. requires printed parts located here 

Printed using state of the art cf-ppa "htn nylon" on an Intamsys Funmat HT  Heat Deflection Temp (HDT) of 220°C [Greater than either Ultem™ 9085 o...

Voron M4 extruder kit for use in Bowden configuration. No printed parts included more information here

Set of screws for Voron v0 as per BOM. Detailed list of content is in the pictures