V2.4

Printed using state of the art cf-ppa "htn nylon" on an Intamsys Funmat HT  Heat Deflection Temp (HDT) of 220°C [Greater than either Ultem™ 9085 o...

Made out of polysulfone (see video) will act as an insulator between bed heater and frame to keep the heat on the bed  **set of 4 per order**

Heat inserts (x30) with heat insert tool from LDOHeatset Insert Tool Guide | LDO Docs (ldomotors.com)

used for input shaper in klipper The ADXL345 is 3-axis accelerometer with high resolution  measurement at up to +/-16 g. Digital output data is  a...

In stock! **350 mm ships in 15-20days**for Trident and V2.4Set of 3 backers 

Ldo quality rails this time made in 440c stainless steel which makes them last much longer and avoid rust. These are absolutely the best rails LDO ...

Z endstop pcb by hartk

The Mosquito™ Hotend is the next step in the evolution of hotend technology. With incredible heat break performance, high-temperature rating, ...

Fully built voron afterburner tool head pcb including the male connector 

Full Ldo v2.4 Motor kit1 - LDO-42STH20-1004ASH(VRN) NEMA 17. 1.8° Step Angle. 200 Steps Per Revolution. 1.0 Amp 1.8Kgf cm Holding Torque. 20m...

SKR V1.4 Turbo Features  BTT SKR V1.4 with 32-bit main frequency 100MHz ARM level Cortex-M3 series LPC1768 main control chip, the performance h...

Endstop pcb for x and y available in both mechanical and hall effect versions. requires printed parts located here 

Check out the newly updated Mosquito® Magnum! Now with a coated heat break! The Mosquito® Magnum prints upwards of 30 mm^3/sec A thermal...

klipper expander is a Simple MCU board for use with Klipper 3D Printer firmware with: STM32F042F6P6 MCU with internal oscilator SWD (Serial Wire De...

Bmg kit by runice, for afterburner and mini afterburner 

The Galileo Clockwork is designed as a drop-in replacement for the existing Afterburner Clockwork module, and uses the same basic core components a...

Voron 2.4 fastener kit by fystec 

in standard spherical bearings, the spherical ball is made from iglide® L280 material, which is known for the lowest coefficients of friction in dr...

Ldo quality rails this time made in 440c stainless steel which makes them last much longer and avoid rust. These are absolutely the best rails LDO ...