Skip to content
New Fabreeko PEI beds for Ender series, cr-10 v3 and cr-6 now available!
New Fabreeko PEI beds for Ender series, cr-10 v3 and cr-6 now available!

Bondtech Drive gears kit

$27.00
Size

These drivegear kits come as a set consisting of a primary drive gear, a secondary drive gear, bearings and a shaft.

  • Gear set for filament size 1.75 mm, primary gear with inner diameter 5 mm, secondary gear with two needle bearings,M3x2 setscrew and one 3 x 20 mm shaft.
  • Gear set for filament size 1.75 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4 x 22 mm shaft.
  • Gear set for filament size 2.85 – 3.0 mm, primary gear with inner diameter 8 mm, secondary gear with integrated needle bearings, M4x3 setscrew and one 4 x 22 mm shaft.

A Lithium based grease is recommended to use on the gear section and inside the needle bearings for low friction and to avoid wear. A small dab of grease is enough.